GARAŽA forum

Ovaj jedan je svetu dovoljan, ostali ne moraju da se muče za džabe

Dabome, Bogotac, ima ga i na oglasima, da ne bude da offtopikujemo

Sent from my SM-N910C using Tapatalk

Malo je samo boja zenskasta na tom sa oglasa

Sent from my Sony

Pa to da ne bude bas ubica, nego ubica mekog srca.

Sent from my SM-N910C using Tapatalk

Hahaha, Kazanova, jebac presretac

Sent from my Sony

Da bre, smeker, jebac i karatista.

Sent from my SM-N910C using Tapatalk

Sad sam pogledao na polovnim automobilima, pretpostavljam da je to taj "GTD 2.0 TDI 184 KS". Koliko dobro izgleda! Na koju foru je ovoliko dobro sačuvan za 100k km

Pa covek je vozio svakodnevno bas velike ture, a voli takva kola. Pre ovoga je imao G6 GTD, sad A3 Sedan 2 0 TDI 184 KS S line, svi crveni.

Sent from my SM-N910C using Tapatalk

Strava, oduševio sam se kad sam video fotke.

Vrlo interesantna je priča oko ove verzije...auto za ljubitelje dobre vožnje

http://www.polovniautomobili.com/putnic ... si-m-paket


Designed to comply with FIA homologation regulations, only 2,600 cars will be sold worldwide. All feature a hand-built four-cylinder engine made at BMW's engine plant at Hams Hall, near Coventry. The high revving 2.0-litre unit delivers 173hp at 7,000rpm (before reaching its red line at 7,300rpm) and 200Nm of torque at 4,250rpm.

This engine powers the BMW from zero to 62mph in 8.1 seconds and, if left unchecked, onto a top speed of 140mph.
This high level of performance has been achieved using BMW's motorsport technology. Compared with the 'standard' BMW 320i, the engine has been significantly modified with larger induction and exhaust valves to increase airflow. The cylinder bore has increased by 1mm to 85mm while the stroke has been reduced by 2mm to 88mm.

The compression ratio of the engine has also been increased from 10.5:1 to 11.0:1, helping to boost power by 23hp over the 320i. Additionally, instead of running with grey-cast-iron cylinder liners, the pistons run in special aluminium-alloy liners in the cylinder block. Engineers have also decided to remove BMW's patented VALVETRONIC induction system, reverting to a conventional throttle due to the higher engine speeds demanded by a racing engine.

In a direct link with BMW's motorsport programmes, the cylinder head is cast at BMW's Landshut foundry alongside Formula One engine blocks. Additionally, to save approximately 10kgs of weight and lower the car's centre of gravity, the cylinder head cover is made of carbon fibre.

The new BMW 320si mates its high levels of performance with World Touring Car looks. The specification of the 320si is based on the 3 Series M Sport model that includes front and rear aerodynamic body styling, sports seats, sports suspension and aluminium interior trim. Additionally, the BMW 320si features Touring Car-style alloy wheels with BMW Motorsport motif. The front wheels are 8J x 18 fitted with 225/40 R18 tyres while at the rear the 8.5J x 18 wheels are fitted with 255/35 R18 tyres. Finally, mirror caps finished in satin chrome differentiate the car from a standard 3 Series.

Uh da, Si, tako rado bih ga posedovao. Secam se kad se pojavio da sam rekao to je to.

Sent from my SM-N910C using Tapatalk

baš je lep, čini se da je u sjajnom stanju (bar na slikama)...

Pa i nije neko trkalo, 173HP na 7,000 uz blokadu na 7,3k i
0-100 za 8,1s...
Nevera da nisu imali bolje za limitiranu seriju.

...odlican a jos je i plave boje

Malo torqua